Disabled Optimization – Manually Plan Routes Without Optimization

Disabling optimization lets you plan routes while keeping the exact sequence of addresses as imported. Unlike optimized routes, which reorder stops for efficiency, non-optimized routes follow the original order but still respect turn avoidance, service times, and other navigational constraints. While this can result in longer travel times, it gives you greater control over route structure. This guide explains how to disable optimization, adjust routes manually, and re-enable optimization when needed.

Disable Optimization – Plan Routes Without Optimizing Them

From your Route Planner, you have the option to plan routes without optimizing them. To access your Route Planner, go to “Dynamic Routing” > “Plan New Route” in the Navigation Menu.

Then, choose how you’ll import your route data: Interactive Map Editor, Copy-and-Paste, Upload a File, Import Date, or Upload Scans(s). When asked to select an Optimization Profile, click “Skip“.

Open Your Route Planner

Under “Optimization“, click “Sequence Optimization“. To disable Optimization, toggle the “Optimize Route(s)” switch. Then, specify a Start Location and choose where to end your route:

• End route at any address: When optimization is disabled, the route ends at the last address listed in the uploaded file or spreadsheet.
• End route at departure address (Roundtrip): The route finishes at the same location where it started.

After defining all of the route’s additional parameters, click “Save“.

Next, import your addresses, verify they are geocoded, and click “Finish Import” to finalize.  NOTE: If your preferred planning method is “Upload a File“, be sure to review Route4Me’s spreadsheet formatting requirements if you need assistance.

Modify Planned Routes – Make Changes To Non-Optimized Routes

You can open your non-optimized route in the Route Editor, where it will maintain the same stop sequence as when the addresses were imported. If needed, you can easily modify the route by dragging and dropping destinations to reorder them.

You can also enable Optimization for the route. To do this, click “Edit” in the top menu bar, followed by “Open Route Settings“. Under “Optimization“, click “Enable Optimization“, then toggle the “Optimize Route(s)” switch.

After enabling Optimizations, you’ll need to re-optimize the route by clicking “Route” in the top menu bar, followed by “Re-Optimize This Route“. Route4Me will reorder the addresses to ensure they follow the most optimal sequence.